1
General Discussion / Re: NoirShares Launch in 8 hours, don't panic.
« on: February 28, 2014, 08:35:14 pm »
I already assumed you knew what you were talking about. 
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Discussion / Re: NoirShares Launch in 8 hours, don't panic.
« on: February 28, 2014, 05:54:08 pm »I've been running the pts-getwork with miner.exe ptspool.conf for a couple days now, with R9 280x gpu, not a single blockI was wondering if someone could tell me if I have the NoirShare.conf setup correctly for solo mining gpu.
rpcuser=xxxxxx
rpcpassword=xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
rpctimeout=30
rpcport=18500
rpcallowip=localhost
gen=1
server=1
my ptspool.conf looks like this.
host=127.0.0.1
port=18500
rpcuser=xxxxxx
rpcpass=xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
#Number of threads requesting work from the server in parallel
getwork_threads=8
submit_threads=8
OpenCL devices to run miner on
devices=0,1,2
platform=0
my understanding is that gen=1 is needed for mining.. But should it be zero since the miner.exe is externally mining?
NoirShares.confQuoterpctimeout=30? why???
Quoterpcallowip=localhosti know its the same, but try using the actual ipQuotesubmit_threads=8try lowering this.
either way, is your GPU registering load when you start the miner?
don't know why copied the time out from another conf. I'll change it to ip.. and wouldn't i want more threads?
3
General Discussion / Re: NoirShares Launch in 8 hours, don't panic.
« on: February 27, 2014, 11:57:27 pm »
I've been running the pts-getwork with miner.exe ptspool.conf for a couple days now, with R9 280x gpu, not a single block I was wondering if someone could tell me if I have the NoirShare.conf setup correctly for solo mining gpu.
rpcuser=xxxxxx
rpcpassword=xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
rpctimeout=30
rpcport=18500
rpcallowip=localhost
gen=1
server=1
my ptspool.conf looks like this.
host=127.0.0.1
port=18500
rpcuser=xxxxxx
rpcpass=xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
#Number of threads requesting work from the server in parallel
getwork_threads=8
submit_threads=8
OpenCL devices to run miner on
devices=0,1,2
platform=0
my understanding is that gen=1 is needed for mining.. But should it be zero since the miner.exe is externally mining?
I was wondering if someone could tell me if I have the NoirShare.conf setup correctly for solo mining gpu.rpcuser=xxxxxx
rpcpassword=xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
rpctimeout=30
rpcport=18500
rpcallowip=localhost
gen=1
server=1
my ptspool.conf looks like this.
host=127.0.0.1
port=18500
rpcuser=xxxxxx
rpcpass=xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
#Number of threads requesting work from the server in parallel
getwork_threads=8
submit_threads=8
OpenCL devices to run miner on
devices=0,1,2
platform=0
my understanding is that gen=1 is needed for mining.. But should it be zero since the miner.exe is externally mining?
Pages: [1]
